Nikon FE body Chrome. All seals are replaced.

Specifications Nikon FE

Type: 35mm manual SLR , Nikon FE/FE2 is available in chrome and black finish
Viewfinder: Eye-level pentaprism type, with 93% frame coverage and 0.86X viewfinder magnification with 50mm set at infinity
Viewfinder display: Shutter speed selected, f/number in use via ADR window, and 3 LEDs in 5 exposure graduation display for overexposure ( + ), correct exposure ( O ) & underexposure ( – )
Focusing screen: Split-image microprism type (Type K2) provided as standard; matte type (B) and matte with horizontal and vertical line etchings (E) optionally available.
Mirror: Automatic Instant Quick-return type
Lens mount : Nikon bayonet type
Film advance: Lever provided wind only in single stroke; 30° standoff angle and 135° winding angle. Automatic film advance is possible with optional Motor Drive MD-12.
Shutter : Vertical – travel focal – plane shutter with speeds from 8 to 1/1000 sec., B and M90 (mechanical, 1/90 sec.), automatic shutter speed selection within a range of 8 sec.(actually some minutes) to 1/1000 sec. (8 – 1/4000 sec) Manual shutter speed selection for the 8-1 /1000 sec. Shutter speed indicated in the viewfinder. Shutter release by a shutter button or self-timer. Manual speed of 1/90 (1/250)second (M90) (M250)and B in case battery falls flat. Lever is also used to un-lock the shutter if it jams during exhaustive of power supply.
Multiple exposure lever: Provided, disengages frame counter for correct count
Frame counter: Additive type (S, 0-36); Automatically resets when camera back is opened.
Film rewind: By crank provided after film rewind button is pressed
Exposure meter: Through-the-lens, center-weighted, full-aperture exposure measurement employing two silicon photodiodes (SPD’s) with Nikkor lenses fitted with meter coupling ridge; stop-down metering applies for other lenses; exposure correctly set either automatically or by matching two needles; meter cross-coupled with both lens diaphragm and shutter speed controls, meter powered by two 1.55V silver-oxide batteries or one 3V lithium battery
Accessory shoe : ISO-type built into the finder housing; fitted with hot-shoe contact and electrical safety switch which turns on contact as flash unit is mounted; fitted also with ready-light contact for use with the SB-10 Speedlight Unit, alternate way using PC terminal.
Flash synchronization: Built-in hot shoe for mounting flash unit; sync cord terminal also provided; 1/125 sec. (1/250sec) Synchronization range : For electronic flash units, 1/125 sec.(1/250sec) to 8 sec. plus B and M90;(M250) for flashbulbs, 1/30 sec. to 8 sec. plus B; sync speed of 1/90 sec. fixed when the SB-10 or equivalent is mounted on the AUTO- set FE camera body and the flash unit is switched on, Flash sync via accessory hot shoe or PC terminal.
Film sensitivity range: ASA/ISO 12-6400
Power source: Choice of one 3V lithium battery, two 1.55V silver-oxide batteries, or two 1.5V alkaline-manganese batteries
Exposure meter switch: Light pressure on shutter release button switches meter on; meter stays on for approximate. 30 sec. after finger leaves button, then automatically switches off
Self-Timer: Set/cancel type provided; approximate. 8-14sec. shutter release delay
Shutter Release Button: Switches meter ON when depressed halfway, threaded in center to accept standard cable release.
Dimensions: (W x H x D): 143mm x 90mm x 58mm
Weight : 540g. (550g)